Solution For Two Problems Wall
Solution For Two Problems Wall. Many problems that occur in buildings. Each part has its own problems, including the walls. Two problems that often occur in the wall was water seepage and cracks. If you experience at home, here we describe the causes, solutions and prevention.
This problem can occur because there is a stream of water behind the wall due to seepage of water from the roof, ground, shower, or cracks in the walls. Seepage of this arises because the composition of the plaster are not appropriate.
To prevent this from happening again, you have to dismantle the wall plaster. After that, replace it with a more watertight plastering, namely “Trasram”. The composition of cement, sand, and water should also be appropriate, namely 1: 3: 5.
So that this problem does not happen again, pay attention to the composition of the mortar mix is “Paramount”. If the problem is the leaking pipe, fix the water line. For walls in direct contact with water, such as bathrooms, use “Trasram” wall to a height of 1.5 m. Also use waterproofing layer of water-based (acrylic).
Soft cracked in the wall
Soft crack in the wall is fine cracks on the wall with a size of less than 2 mm. The cause is a stucco composition that does not comply with the standards. Other causes are the stucco work is carried out in hot conditions or wall is too dry.
To fix it, you have to clean up the paint around the cracks to plaster visible. After that, you can use the cement filler to fill the hairline cracks. Once dry, sandpaper until smooth surface so that the patch can not be seen. The latter is do the painting.
So that cracks do not occur, at the time of installation of plaster, wet the first surface of the wall. At the time of the painting process, use a paint that has a high elasticity that is not easily cracked or chipped.